![]() ![]() ![]() I have read elsewhere to pull the transmission pressure regulator valve and the relief valve assembly what does this do and what should i be looking for? I know this is alot in one post but just excited to find knowledgeable folks, been spinning my wheels for far to long dont want to spend a ton of money on new torque converter without knowing its bad for sure. also my gauges on the dash all unfortunately were smashed in by the gentlemen grandson, looking for replacements with not a lot of luck so far, so i do not know what pressure it is generating. if water got in the torque converter could it have ruined it? I know i have drained it now and has new oil in it so i know its good. No external leaks on the dozer other than a few small hydraulic drippings from lines needing replaced. I then pulled the side panel off the torque converter to see it spinning when the machine stalls the flex plates and torque converter both are still spinning, this leads me to believe the torque converter is not producing sufficient pressure thoughts? that cavity was also dry like its supposed to be. To move from one speed to another press the UP (1) or DOWN (2) button. I have checked strainer and replaced the filter behind the seat, also I have pulled charge pump and it seems to be tight and fine. CASE 850K dozer manual - Free download as PDF File (.pdf) or read online for. now when it stalls if i really add additional throttle it will move but doesn't have much torque. I can drop in neutral and put back in gear then it will move again. Case 850m wt lgp, topcon ready package, rear screen, sweeps,center rock guards, radio, complete new u/c including pads, 2301 hours, very nice tight and dry, 108,500. What model 850 To remove the transmission you undo the tracks, disconnect drive shafts hoses etc and the whole assembly comes down and out the back with the finals still attached. The problem the machine now has is it will move forward and reverse, but it stalls and the driveshaft stops spinning. Crawlers, Dozers, Loaders & Backhoes Discussion Forum: Discussion Forums > Crawlers, Dozers, Loaders & Backhoes > Case 850 wont move. I have drained all fluids and replaced multiple times until all fluids were clean. That person then sank it in a mud hole and left it submersed for a good while. ![]() So here is some backstory, the dozer i purchased worked just fine original owner loaned it out. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |